How do you install architectural shingles?

1:463:21How to Install Laminate Architectural Shingles by Malarkey Roofing ...YouTubeStart of suggested clipEnd of suggested clipBeginning. At a lower corner. Starting the first course with a full-length shingle laid directlyMoreBeginning. At a lower corner. Starting the first course with a full-length shingle laid directly over the starter course maintaining the overhang.

Are architectural shingles easier to install than 3?

Three-tab shingles are lightweight and easy to install. They're thinner and look more two dimensional than three dimensional after installation. Usually, three-tab shingles will not last as long, but they are cheaper than architectural shingles.

What is better 3-tab or architectural shingles?

3-tab shingles are flat, and they have a single tab shape and size. They are uniform, which gives them a flat look. Architectural shingles are also referred to as dimensional shingles. This is because they provide a more dimensional look to the roof.

What is the going rate to put on architectural shingles?

The average cost for an architectural shingle roof will range between $13,500 to $21,500 depending on the slope, pitch, and size of your roof. You can expect to pay $1.

Do you need a starter row with architectural shingles?

You do need to use a starter course with architectural shingles. The starter edge will help seal the edges and cover your shingle joints. As it won't be visible on the finished roof, you don't need to worry about the look of your starter strip and whether it matches your architectural shingles.

How to Shingle a roof with architectural shingles?

This diagram shows how to shingle a roof with architectural shingles. Preparing the roof for architectural shingles is the same as for three tab shingles. The ice and water shield is placed on the bottom edge and 15lb felt ( tar paper) is applied to the rest of the roof. Drip edge is placed, and nailed to the perimeter of the roof.

What's the difference between ARC TEC and tab shingles?

Unlike three tab shingles ,arc-tec shingles do not require chalk lines to be placed on the roof to align the shingles too. There are no tabs to be lined up and this is what makes them an easier shingle to install.

What kind of shingles to use for first row?

If using shingles reversed for the starter row, three tab shingles should be used , not the arc-tec shingles .The three tab will create a flatter surface for the first row of shingles. Care should be taken that the end joints of the starter row, are overlapped by the shingles of the first row of arc-tec shingles.

What's the difference between architectural and three tab shingles?

Architectural shingles are practically twice as thick as three-tab shingles. They are also less vulnerable to curling. Increased wind resistance. Architectural shingles weigh approximately 340-440 pounds per square and are rated for wind speeds that are up to eighty to one-hundred and twenty miles per hour.

How do you install architectural shingles?

Table of Contents