Can a regular door be made into a pocket door?

Can a regular door be made into a pocket door?

Can a regular door be made into a pocket door?

As long as the measurement is correct for the pocket opening, the door is the right thickness, and the door hasn't been pre-drilled for a standard door lockset or hinges, you can use any kind of door for a pocket door.

How do you use an existing door as a pocket door?

How to Reuse an Old Hinged Door as a Pocket Door

  1. Measure the width of the pocket gap or hollow-box frame. ...
  2. Measure the height of the pocket framework. ...
  3. Remove the doorknob, latch plate and hinges from the door with a screwdriver.
  4. Fill the holes left by the hinges, latch or deadbolt with wood filler, using a putty knife.

Do Pocket doors save space?

Pocket doors save valuable floor space by eliminating the room you need for traditional doors to swing. Because the door slides into the wall, you need to have enough clearance in the wall framing for the door(s) to fit, and you cannot put any light switches or outlets in those walls (there's no room).

How do you change a hinged door to a pocket door?

Make a line following the top of the door header to the last stud, and cut all the studs at this line except the last one. Remove the studs. Cut the bottom plate flush with the last stud and remove it. Remove the old header, and replace it with a longer one that extends to the last uncovered stud.

What do you need to make a pocket door?

Pocket doors also require modification of the wall framing since you need to make a space for the door in the wall and create a slot in the stud framing the door. Remove the old door, door trim and jamb. Remove the drywall from one side of the wall to uncover enough space for the door pocket.

How do you attach a pocket door to a car?

Attach the pocket-door hardware to the top and bottom of the door with a screwdriver. Tilt the top of the door toward the upper track to insert the rollers into the track’s groove.

How is the width of a pocket door determined?

The width of the new opening, which is the distance between the new jack stud and the one that frames the far side of the existing door, is specified in the instructions that come with the pocket door kit. After setting the header, you're ready to install the pocket door frame.


Related Posts: